涂料供应
溶剂室流体
空气润滑器
确保
虹吸杆和过滤器浸没在涂层材料中，或
压力供给系统正在运行
油气连接紧密
空气滤清器已排空
压缩空气可用于运行泵
排放杆于接地的废物容器
泵、涂料供应和废物容器接地
启动
1、使用以下公式计算
产生所需的输出压力：
输出压力泵比=所需空气压力
例如，您希望输出压力为1200 psi。计算
所需气压如下：
15： 1台泵：1200 psi 15=80 psi所需气压。
30:1泵：1200 psi 30=40 psi所需气压。
注意：喷枪处的流体压力会有所不同，具体取决于
因素，包括材料粘度和温度、过滤器数量
和加热器，以及流体软管ID和长度。在以下位置安装液压表
用于确定实际流体压力的喷枪。
2、打开空气切断阀并调节空气，启动泵
将压力调节器调节到将产生所需压力的空气压力
输出压力。
F7553 -1Check the levels of thecoating material supply (5)
solvent chamber fluid (see Figure B 4-1)
air lubricator (4)
Make sure that the
siphon rod and strainer (6) are submerged in coating material, or
pressure-feed system is operating
fluid and air connections are tight
air filter (2) has been drained
compressed air is available to run the pump
drain rod (12), if used, is in a grounded waste container (13)
pump, coating material supply, and waste container are grounded
Startup
1. Use the following formula to calculate the air pressure required to
produce the desired output pressure:
output pressure pump ratio = air pressure required
For example, you want an output pressure of 1200 psi. Calculate the
required air pressure as follows:
15:1 pump: 1200 psi 15 = 80 psi air pressure required.
30:1 pump: 1200 psi 30 = 40 psi air pressure required.
NOTE: The fluid pressure at the spray gun(s) will vary, depending on many
factors, including material viscosity and temperature, the number of filters
and heaters, and fluid hose ID and length. Install a fluid pressure gauge at
the spray gun(s) to determine the actual fluid pressure.
2. Start the pump by opening the air shutoff valve (1) and adjusting the air
pressure regulator (3) to the air pressure that will produce the desired
output pressure.
客服1