将所有导电设备接地。仅使用接地的空气和液体
软管。定期检查设备和工件接地装置。
接地电阻不得超过1兆欧。
如果发现静电火花或
电弧。在查明原因之前，不要重新启动设备
并已更正。
请勿在易燃的地方吸烟、焊接、打磨或使用明火
正在使用或存储材料。
不要将材料加热到高于
制造商。确保热监控和限制装置
工作正常。
提供足够的通风，以防止危险的
挥发性颗粒或蒸汽。参考当地规范或材料MSDS
用于指导。
在处理易燃物品时，不要断开带电电路
材料。首先切断断路开关处的电源，以防止
火花
To avoid a fire or explosion, follow these instructions.Ground all conductive equipment. Use only grounded air and fluid
hoses. Check equipment and workpiece grounding devices regularly.
Resistance to ground must not exceed one megohm.
Shut down all equipment immediately if you notice static sparking or
arcing. Do not restart the equipment until the cause has been identified
and corrected.
Do not smoke, weld, grind, or use open flames where flammable
materials are being used or stored.
Do not heat materials to temperatures above those recommended by
the manufacturer. Make sure heat monitoring and limiting devices are
working properly.
Provide adequate ventilation to prevent dangerous concentrations of
volatile particles or vapors. Refer to local codes or your material MSDS
for guidance.
Do not disconnect live electrical circuits when working with flammable
materials. Shut off power at a disconnect switch first to prevent
sparking
客服1